Maintenance Plans & What's Included

● Clean outdoor condenser to remove cottonwood, dirt, debris, etc.

● Measure refrigerant pressures

● Test capacitor, contactor, fan motor, and compressor amps

● Check/measure the power supply to disconnect

● Check drains and clear if necessary

● Inspect the evaporator coil and blower motor

● Check duct/design for air leakage and properly sealed

● Measure insulation-inches

● Check the cleanliness of ductwork

● Check for mold presence

● Ensure the system is sealed properly

● Measure for correct airflow

● Test amp draw of blower motor

● Check/tighten all electrical components

● Test starting capabilities and safety controls

● Monitor the cooling cycle

● Replace filters (extra charge)

● Clean and adjust burner assembly - if applicable

● Examine the heat exchanger for any issues

● Check and clean flame sensor and burner assembly

● Measure the flue draft

● Check all flue pipe connections

● Check clearance and strapping per code

● Adjust gas pressure - if needed

● Check gas piping for leaks

● Verify drip leg is installed

● Check R-value of the duct and for air leaks

● Measure insulation-inches

● Measure for correct air flow/balance

● Check for any presence of mold

● Check for dirt/debris on evaporator - lightly clean (does not include deep cleaning)

● Tighten all electrical connections

● Check amp draws

● Test starting capabilities and safety controls

● Monitor heating cycles

● Check drains and clear if necessary

● Replace filters (extra charge)